Fine Blanking Press -hydraulical- FEINTOOL FB ONE 11000

CONTROLS
  PC controller BECKHOFF

PRESS DESIGN
  drive system: servohydraulic
  frame design: H-frame, tie rod
  quick die change system: yes
  feedstock transport direction: left to right

SLIDE
  total force (nominal): 1100 to
  stroke: 130 mm
  stroke rate (max.): 60 /min

COUNTER RAM
  nominal force: 330 to
  stroke: 40 mm

V-RING
  nominal force: 500 to
  stroke: 40 mm

TOOL DIMENSIONS
  lower table (left-right): 960 mm
  lower table (front-back): 960 mm
  upper table (left-right): 960 mm
  upper table (front-back): 960 mm
  shut height max.: 470 mm

OVERALL SPECIFICATIONS (COIL LINES)
  sheet width max.: 500 mm
  sheet thickness max.: 16 mm
  coil weight max.: 8 to
  feedstock transport direction: left to right

COIL CHAIR
  coil weight max.: 8 to
  stroke: 700 mm

DECOILER
  coil weight max.: 8 to
  max. diameter of coil: 1800 mm
  mandrel expansion range from: 470 mm
  mandrel expansion range up to: 530 mm

LEVELLER UNIT
  sheet width max.: 500 mm
  sheet width (min): 80 mm
  sheet thickness max.: 16 mm
  sheet thickness min.: 1.5 mm
  material cross section max. (450 N/mm2): 3510 mm²
  number of leveller rolls: 17
  integrated feed function: yes
  intermediate clamp release: yes
  cleaning device for leveller rollers: yes

CROP SHEAR
  cutting force: 800 kN

ELECTRICAL SPECIFICATIONS
  mains power supply: 350 kVA
  mains voltage: 400 V
  mains frequency: 50 Hz

DIMENSIONS / WEIGHTS
  total weight approx.: 75350 kg


Absolutely mint condition: just 3300 running hours, 700000 strokes

Special equipment fineblanking press:+ block hydraulics for 4th and 5th force. High pressure 30-270 bar.+ mechanical reamers (without tool-bound sliders)+ additional operating mode cutting without counter-holder and V-ring+ additional operating mode manual insert mode+ 2 blast air circuits with 6 connections each+ Additional tool monitoring+ RAZIOL roller belt lubrication system with 2 reservoirs+ Interface for monitoring the cooling system
- the scrap conveyor (visible on photos) is not part of the scopeARKU single reel with loading chair:+ 2 pressure arms for high-strength coil material+ Coil guidance via conical rollers+ Automatic coil centre positioningARKU feed straightening machine:max. straightening cross-section at 600 N/mm2: 3510 mm2+ Synchronised drive of the straightening rollers+ Hardened and ground straightening rollers+ Servo-hydraulic leveller gap control+ Straightening roller quick-change system+ intermediate roller release+ Measuring wheel for feed control

seller offer No. resale 50429