We use cookies to optimize our website for you and to be able to continuously improve it. By continuing to browse the site you are agreeing to our use of cookies.
Disagree
Type of machinery
(Quantity: > 4)
Manufacturer:
(Category: 1300)
3. Second-hand overhead crane For loading the slabs! Spam: 25 m Capacity: 5 tons Total weight: 32 500 kg
2. Qty. 9 Second-hand slab pit type furnaces Mfc.: Ebner Type: Electrical heated Built: 1970 Stopped: 2019 Power: 600 kW Number of heating units: 5 Weight capacity: 20.000 kg Voltage supply: 380 V, 50 Hz Compressed air: 5 bar Max. temperature: 650 °C Slab number: 7 slabs; 8 slabs, if the width 700 - 800 mm and 10 slabs, if the width 700 mm Slab length: Max. 3300 mm (in furnaces 1 to 5) and Max. 3000 (in furnaces 6 to 9) DIMENSIONS (outer): 2000 x 2580 x 4080 mm – H x W xL
1. Qty. 1 Second-hand slab gas fired pit type furnace Manufacturer: Tehnika Set Type: Gas heated (2 Zones) Built: 2001 Stopped: 2019 Power: 110kW Number of heating units: 8 Dim.: 2622 5084 x 6294 mm – H x W x L Inner dimension per zone: LxWxH – 380026001635 mm Load weight max. / 2 zones: 42.000 kg Max. Slab number per zone: 5 Slab length: 3000 mm Voltage supply: 380 V, 50 Hz Compressed air: 5 bar Max. Temp.: 630 °C
used
High-temperature chamber furnace with an operating temperature of up to 2,000 °C, including water cooling and sequence control with automatic valves. Usable space: 600 mm x 600 mm x 600 mm (= 220 l.), el. Power: 117 kW,
used
Twin-shaft crusher / lump crusher for crushing and loosening lumpy material. Drive via Bauer geared motor with 5.5 kW and friction clutch. Infeed dimension: 1,000 mm x 280 mm.
used
used
Multi-wire cutter with slat feed and chunk cutter 13 stones in NF format with three-sided chamfering. Batten length 1340 mm
used
45 cycles per minute with chamfering 60 cycles per minute without chamfering Maximum cutting length 700 mm, width 400 mm
used
Roll gap from 0.6 mm. New roller shells. Power at gap of 0.8 mm is 40t
used
Compressed air-cleaned dust filter with stainless steel housing, filter area: 10 m², filter media: 4 filter cartridges, incl. ESM-3 control unit and manifold for flange mounting on the underside. Filter was used for dedusting a horizontal mixer for mineral building materials.
used
Wide-chamber pin mill with grey cast iron housing, output / throughput: 600 kg/h max. (depending on material), required motor power: 12 kW to 22 kW (optional). Rotor and stator disc in very good condition. Cleaned, anti-rust primed and repainted. Rust protection inside can be easily removed before commissioning.
used
Batch ball mill made in Germany with a gross volume of 400 l., drive via V-belt and gear motor with 2.2 kW, iron-free lining (aluminium oxide), previous use: glaze production in the wet grinding process. Cleaned, repainted and restored. Available for an extra charge: iron-free grinding media (balls, alubit).